FRONT AXLE ± Front Differential Mount
26-50
FRONT DIFFERENTIAL MOUNT
REMOVAL AND INSTALLATION
Caution
1. To remove the differential mount crossmember assembly, support the front differential assembly
with a jack.
2. To prevent bushings from breakage, the parts indicated by * should be temporarily tightened,
and then fully tightened with the vehicle on the ground in the unladen condition.
98 ± 118 Nm*
1
103 Nm
93 Nm*
42 Nm
42 Nm
103 Nm
2
3
4
Differential mount bracket assembly
(front) removal steps
D Free-wheeling clutch assembly
removal (Refer to P. 26-45.)
1. Differential mount bracket assembly
<front>
Differential mount bracket assembly
(LH, RH) removal steps
D Drive shaft assembly removal
(Refer to P. 26-19.)
2. Differential mount bracket assembly
<Rear ± LH>
3. Differential mount bracket
<Rear ± RH>
Differential mount crossmember
assembly removal steps
D Front propeller shaft removal (Refer
to GROUP 25.)
4. Differential mount crossmember
assembly
To Next Page
Loading...
