Mitsubishi Pajero Pinin 1999 - Sealants

ENGINE <4G9-GDI> ± Service Specifications/Sealants
11A-3
Items LimitStandard value
Power steering oil pump and
A/C com
p
ressor drive belt
Vibration frequency Hz 114 ± 139 ±
A
/C
compressor drive belt
tension (When checked)
Tension N 392 ± 588 ±
( )
Deflection (Reference value) mm 10.0 ± 12.0 ±
Power steering oil pump and
A/C com
p
ressor drive belt
Vibration frequency Hz 121 ± 133 ±
A
/C
compressor drive belt
tension (When adjusted)
Tension N 441 ± 539 ±
( j )
Deflection (Reference value) mm 10.0 ± 11.0 ±
Power steering oil pump and
A/C com
p
ressor drive belt
Vibration frequency Hz 145 ± 166 ±
A
/C
compressor drive belt
tension (When replaced)
Tension N 637 ± 834 ±
( )
Deflection (Reference value) mm 7.0 ± 9.0 ±
Basic ignition timing 5_ BTDC ± 3_ ±
Ignition timing Approx. 16_BTDC*
1
±
Idle speed r/min 600 ± 50*
1
±
CO contents % 0.6 or less ±
HC contents ppm 200 or less ±
Compression pressure kPa ± r/min 1,720 ± 300 1,337 ± 300
Compression pressure difference of all cylinder kPa ± Max. 100
Intake manifold vacuum kPa ± Min. 60*
2
Cylinder head bolt shank length mm ± 96.4
Auto-tensioner push rod movement mm Within 1 ±
Timing belt tension torque Nm (Reference value) 2.5 ± 4.0 ±
Auto-tensioner rod protrusion amount mm 3.8 ± 4.5 ±
NOTE
*
1
: Indicates the value measured within 4 minutes since the engine was started.
*
2
: Indicates the value when more than 4 minutes have passed since the engine was started.
SEALANTS
Items Specified sealants Remarks
Beam camshaft cap
Cylinder head
3M ATD Part No.8660 or equivalent ±
Cam position sensor support
Oil pan
MITSUBISHI GENUINE PART
MD970389 or equivalent
Semi-drying sealant
Thrust case
Flywheel or drive plate bolt
3M Stud Locking 4170 or equivalent ±