CHASSIS ELECTRICAL ± Headlamp, Front Turn-signal Lamp and Front Fog LampCHASSIS ELECTRICAL ± Headlamp, Front Turn-signal Lamp and Front Fog Lamp
54A-33
FRONT FOG LAMP AIMING
1. Measure the centre of the front fog lamps, as shown in
the illustration.
2. Set the distance between the screen and the centre of
the front fog lamps as shown in the illustration.
3. Inflate the tyres to the specified pressures and there should
be no other load in the vehicles other than driver or
substituted weight of approximately 75 kg placed in the
driver's position.
4. With the engine running at 2,000 r/min, aim the front fog
lamp.
5. Check if the beam shining onto the screen is at the standard
value.
Standard value:
(Vertical direction)
100 mm below horizontal (H)
(Horizontal direction)
Parallel to direction of vehicle travel
NOTE
The horizontal direction is non-adjustable. If the deviation
of the light beam axis exceeds the standard value, check
to be sure that the mounting location or some other point
is not defective.
Caution
When making the aiming adjustment, be sure to mask
those lamps which are not being adjusted.
Lamp centre
Screen
5 m
Fog lamp centre line
Vehicle centre line
Lamp centre
Distance of
vertical direction
Centre of high
intensity zone
High intensity zone
Adjusting screw
To Next Page
Loading...
