Heater Unit, Blower Unit, Resister and
Evaporator/Compressor and Tension Pulley
HEATER, AIR CONDITIONER
AND VENTILATION
±
55-26
INSIDE/OUTSIDE CHANGEOVER DAMPER MOTOR
CHECK
Battery connection terminal
Lever operation
4 6 7
Moves to the inside air
position
Moves to the outside air
position
Caution
Cut off the battery voltage when the damper is in the
inside air position or outside air position.
COMPRESSOR AND TENSION PULLEY
REMOVAL AND INSTALLATION
Pre-removal Operation
Discharging of Refrigerant (Refer to P.55-13.)
Post-installation Operation
D Charging of Refrigerant (Refer to P.55-10.)
D Drive Belt Tension Adjustment
(Refer to GROUP 11 ± On-vehicle Service.)
1
4
3
3
4
25 Nm
2
5
Piping connection
Compressor oil:
ZXL 200PG
OĆring
Removal steps
D Washer tank
(Refer to GROUP 51.)
1. Drive belt (Refer to GROUP 11.)
2. Tension pulley
AA" 3. Suction hose and discharge hose
connection
D Under cover
AB" " AA 4. Compressor
5. Compressor bracket
Inside/outside air change-
over damper motor
To Next Page
Loading...
