SRS ± Seat Belt with Pre-tensioner
52B-44
SEAT BELT WITH PRE-TENSIONER
Caution
1. Never attempt to disassemble or repair the
seat belt with pre-tensioner. If faulty, replace
it.
2. Be extremely careful when handling the seat
belt with pre-tensioner. Do not subject it to
shocks, drop it, bring it close to strong
magnets or allow contact with water, grease
or oil. Always replace it with a new part if
any dents, cracks or deformation is found.
3. Do not place anything on top of the seat
belt pre-tensioner.
4. Do not expose the seat belt with
pre-tensioner to temperatures over 90_C.
5. After operating the seat belt pre-tensioner,
replace the seat belt pre-tensioner with a
new part.
6. Gloves and protective goggles should be
worn when handling a pre-tensioner once
it has been used.
7. If disposing of a seat belt with pre-tensioner
which has not yet been used, its
pre-tensioner should be operated first before
disposal. (Refer to P.52B-48.)
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
D Turn Ignition Key to LOCK (OFF) Position
D Disconnect the Negative (±) Battery Terminal.
44 Nm
2
1
44 Nm
1
44 Nm
Removal steps
1. Outer seat belt connection
D Quarter Trim (Refer to GROUP 52A.)
2. Seat belt with pre-tensioner
Installation steps
" AA D Post-installation inspection
2. Seat belt with pre-tensioner
D Quarter Trim (Refer to GROUP 52A.)
1. Outer seat belt connection
D Negative (±) battery cable connection
" BA D Pre-installation inspection
NOTE
The figure shows the seat belt with pre-tensioner
(R.H.)
To Next Page
Loading...
