SRS ± Seat Belt with Pre-tensioner
52B-45
INSTALLATION SERVICE POINTS
" AA PRE-INSTALLATION INSPECTION
When installing a new seat belt with pre-tensioner refer to
ªINSPECTIONº.
Caution
Disposal of the pre-tensioner must be carried out as stated
in the procedure. (Refer to P.52B-48.)
" BA POST-INSTALLATION INSPECTION
1. Reconnect the negative battery terminal.
2. Turn the ignition key to the ªONº position.
3. Does the ªSRSº warning lamp illuminate for about 7
seconds, and then remain extinguished for at least 5
seconds after turning OFF?
4. If yes, SRS system is functioning properly. If no, consult
page 52B-8.
INSPECTION
SEAT BELT WITH PRE-TENSIONER CHECK
If any part is found to be faulty during the inspection, it must
be replaced with a new one.
Dispose of the old one according to the specified procedure.
(Refer to P.52B-48.)
D Check seat belt pre-tensioner for dents, cracks or
deformation.
SRS warning lamp
To Next Page
Loading...
