AUTOMATIC TRANSMISSION ± Transmission Control
23-50
TRANSMISSION CONTROL
REMOVAL AND INSTALLATION
Caution
Do not strike the SRS-ECU when removing and installing the transmission control cable, key interlock
cable, shift lever assembly and the A/T-ECU.
Sealant:
3M Stud Locking
No.4170 or equivalent
Apply sealant
to both sides
Sealant:
3M ATD Part No.8663
or equivalent
11
12
9
8
10
2
1
7
6
5
3
4
12 Nm
12 Nm
12 Nm
15 ± 22 Nm
9, 11
12 Nm
13
6
Selector lever assembly and
transmission control cable assembly
removal steps
D Rear floor console assembly
(Refer to GROUP 52A.)
1. Key interlock cable connection
2. Shift lock cable connection
3. Transmission control cable connection
(selector lever side)
4. Selector lever assembly
5. Transmission control cable connection
(transmission side)
Transfer control lever assembly
removal steps
D Front floor console assembly
(Refer to GROUP 52A.)
6. Retainer plate
" AA 7. Transfer lever inner boot
8. Transfer control lever assembly
9. Gasket
10. Stopper plate
11. Gasket
12. Transfer control lever
Wide open throttle switch removal
13. Wide open throttle switch
To Next Page
Loading...
