REAR AXLE ± Axle Shaft
27-11
AXLE SHAFT
REMOVAL AND INSTALLATION
Pre-removal Operation
Brake Fluid Draining (Refer to GROUP 35A ± On-vehicle
Service.)
Post-installation Operation
D Brake Fluid Filling and Air Bleeding (Refer to
GROUP 35A ± On-vehicle Service.)
D Parking Brake Lever Stroke Adjustment (Refer to
GROUP 36 ± On-vehicle Service.)
7
9
10
8
3
11
12
1
88 Nm
(Oil lip part)
6
5
4
15 Nm
2
Removal steps
1. Brake tube
2. Caliper assembly
3. Brake disc
4. Parking brake shoe (Refer to
Group 36 ± Parking brake drum.)
5. Parking brake cable connection
6. Wheel speed sensor <Vehicles with
ABS>
7. O-ring <Vehicles with ABS>
AA" 8. Axle shaft assembly
" BA 9. Packing(s)
" BA 10. Shim(s)
" BA 11. Packing(s)
AB" " AA 12. Oil seal
REMOVAL SERVICE POINTS
AA" AXLE SHAFT ASSEMBLY REMOVAL
Use the special tools to remove the axle shaft assembly.
Caution
Be careful not to damage the oil seal when pulling the axle
shaft.
MB990211
MB990244 (Three)
MB991354
To Next Page
Loading...
