REAR AXLE ± Axle Assembly
27-10
REMOVAL SERVICE POINTS
AA" REAR PROPELLER SHAFT DISCONNECTION
Make mating marks on the companion flange and the flange
yoke, and then disconnect the propeller shaft from the
companion flange.
Caution
Use a wire, etc. to suspend the propeller shaft from the
body to prevent it from falling.
AB" SHOCK ABSORBER DISCONNECTION
Support the axle housing with a jack before removing the
shock absorber lower mounting nut.
AC" LATERAL ROD DISCONNECTION
Disconnect the lateral rod from the axle assembly, and then
use a wire, etc. to suspend the lateral rod to prevent it from
falling.
AD" AXLE ASSEMBLY REMOVAL
Take out the axle assembly toward the rear of vehicle.
Caution
Take out the axle assembly carefully and slowly. The axle
assembly is heavy and unstable and may fall.
To Next Page
Loading...
