CLUTCH ± Clutch Control
21-7
DISASSEMBLY AND REASSEMBLY
CLUTCH MASTER CYLINDER
Caution
Do not disassemble piston assembly.
1
4
5
6
2
8
2
2
3
4
Grease: Rubber grease
Clutch fluid:
Brake fluid DOT3 or DOT4
Piston repair kit
9
9
7
12 Nm
1
2
3
10
7
11
9
Disassembly steps
1. Piston stopper ring
2. Piston assembly
" AA 3. Push rod assembly
4. Boot
5. Nipple <L.H. drive vehicles>
6. Reservoir cap <R.H. drive vehicles>
7. Spring pin
8. Reservoir tank <R.H. drive vehicles>
9. Seal
10. Master cylinder body <L.H. drive
vehicles>
11. Master cylinder body <R.H. drive
vehicles>
INSTALLATION SERVICE POINT
" AA PUSH ROD ASSEMBLY INSTALLATION
Set the length of the push rod assembly to the shown dimension
to make the adjustment of clutch pedal easier.
<L.H. drive vehicles> 103 mm
<R.H. drive vehicles> 126 mm
To Next Page
Loading...
