CHASSIS ELECTRICAL ± Headlamp, Front Turn-signal Lamp and Front Fog Lamp
54A-34
BULB REPLACEMENT
<Headlamp Bulb>
1. Disconnect the connector.
2. Remove the socket cover.
3. Remove the bulb mounting spring, and then withdraw the
bulb.
4. Install new bulb, and then connect the connector securely.
Caution
Do not touch the surface of the bulb with hands or dirty
gloves. If the surface does become dirty, clean it with
alcohol or thinner, and let it dry thoroughly before
installing.
<Position Lamp Bulb>
Remove the lamp socket by turning it anti-clockwise, then
pull out the bulb from the socket.
<Front fog lamp Bulb>
1. Remove the front fog lamp.
2. Remove the front fog lamp cover.
3. Remove the front bulb mounting spring, and then withdraw
the bulb.
4. Disconnect the connector, and then replace the bulb.
Caution
(1) Always use the genuine part for replacement.
(2) Do not touch the surface of the bulb with hands
or dirty gloves. If the surface does become dirty,
clean it with alcohol or thinner, and let it dry
thoroughly before installing.
(3) Be sure to install the socket cap. If the socket
cap is improperly installed, the lens will be fogged
or water may enter the lamp unit.
Spring
Position lamp bulb
Fog lamp cover
Spring
To Next Page
Loading...
