AUTOMATIC TRANSMISSION ± Transmission Assembly
23-56
TRANSMISSION ASSEMBLY
REMOVAL AND INSTALLATION
Caution
Mounting locations marked by * should be provisionally tightened, and then fully tightened after
placing the vehicle horizontally and loading the full weight of the transmission on the vehicle body.
Pre-removal and Post-installation Operation
D Transfer Control Lever Assembly Removal and
Installation (Refer to P.23-50.)
D Under Cover Removal and Installation
D Transmission Fluid and Transfer Oil Draining and
Filling (Refer to P.23-35, 39.)
D Front and Rear Propeller Shaft Removal and
Installation (Refer to GROUP 25.)
D Air Cleaner Removal and Installation (Refer to
GROUP 15 ± Air Cleaner and Resonance Tank.)
D Front Exhaust Pipe and Catalytic Converter Removal
and Installation (Refer to GROUP 15.)
D Vacuum Actuator Assembly Removal and Installation
(Refer to GROUP 26 ± Main Shaft.)
D Kick-down Cable Adjustment <Only after installation>
(Refer to P.23-37.)
D Accelerator Cable Assembly Check and Adjustment
<Only after installation> (Refer to GROUP 17 ±
On-vehicle Service.)
1
3
12
10
9
8
7
6
5
2
13
16 Nm
11
4
26 ± 33 Nm
Removal steps
1. Kick-down cable connection
2. Oil level gauge assembly
3. Transmission control cable connection
4. Dust shield guard
AA" 5. Starter motor
6. Vehicle speed sensor connector
7. VCU lock detection switch connector
8. 2WD/4WD detection switch connector
9. VCU lock operation detection switch
connector
10. High/Low detection switch connector
11. 4WD operation detection switch
connector
12. Harness connector
13. Inhibitor switch connector
To Next Page
Loading...
