Mitsubishi Pajero Pinin 1999 - Page 347

AUTOMATIC TRANSMISSION ± A/T Key Interlock and Shift Lock Mechanisms
23-55
INSTALLATION SERVICE POINTS
" AA SHIFT LOCK CABLE (SELECTOR LEVER SIDE)
INSTALLATION
1. Move the selector lever to P position.
2. Move the shift lock cable to position the shift lock cable
end above the red marking painted on the lock cam, and
then tighten the shift lock cable fixing nut to the specified
torque.
Tightening torque: 12 Nm
3. Check that the shift lock mechanism operates normally.
(Refer to P. 23-49.)
" BA KEY INTERLOCK CABLE (STEERING LOCK
CYLINDER SIDE) INSTALLATION
Turn the ignition key to LOCK (OFF) position, and then install
the key interlock cable.
" CA KEY INTERLOCK CABLE (SELECTOR LEVER
SIDE) INSTALLATION
1. Move the selector lever to P position.
2. Turn the ignition key to LOCK (OFF) position.
3. Connect the key interlock cable end to the lock cam.
4. Install the key interlock cable temporarily.
5. Tighten the key interlock cable fixing nut to the specified
torque with the lock cam pushed in the direction A (shown
in the illustration).
Tightening torque: 12 Nm
6. Check that the key interlock mechanism operates normally.
(Refer to P. 23-48.)
Lock cam
12 Nm
Shift lock cable
Red marking
A
Lock cam
12 Nm