SRS ± SRS Maintenance
52B-23
SRS MAINTENANCE
The SRS must be inspected by an authorized dealer 10 years
after the date of vehicle registration.
SRS WARNING LAMP CHECK
Turn the ignition switch to the ªONº position. Does the SRS
warning lamp illuminate for about 7 seconds, turn off and
then remain extinguished for at least 5 seconds? If yes, SRS
system is functioning properly. If no, consult page 52B-8.
SRS COMPONENT VISUAL CHECK
Turn the ignition key to LOCK (OFF) position, disconnect the
negative battery cable and tape the terminal.
Caution
Wait at least 60 seconds after disconnecting the battery
cable before doing any further work. (Refer to P.52B-4.)
SRS CONTROL UNIT (SRS-ECU)
1. Check SRS-ECU case and brackets for dents, cracks,
deformation or rust.
Caution
The SRS may not activate if the SRS-ECU is not
installed properly, which could result in serious injury
or death to the vehicle's driver or front passenger.
2. Check connector for damage, and terminals for
deformation or rust.
Replace SRS-ECU if it fails visual check.
(Refer to P.52B-34.)
FRONT IMPACT SENSORS
1. Check the front side member for deformation or rest.
2. Check the front impact sensor for dents, cracks,
deformation or rust.
3. Check the sensor harnesses for binding, the connectors
for damage, and the terminals for deformation.
SRS warning lamp
Battery (±) cable
Insulating tape
Battery
SRS-ECU
Front side member
Front impact
sensor
Forward
To Next Page
Loading...
