AUTOMATIC TRANSMISSION ±
Service Specifications/
Lubricants/Sealants and Adhesives
23-2
SERVICE SPECIFICATIONS
Items Standard value
Clearance between inner cable stopper and dust cover end surface mm 0.8 ± 1.5
Input shaft speed sensor resistance (at 20_C) Ω 620 $ 60
Output shaft speed sensor resistance (at 20_C) Ω 430 $ 43
A/T fluid temperature sensor resistance Ω
at 25_C 1,100
at 120_C 57
Coil resistance of solenoid valve No.1 (at 25_C) Ω 13 $ 2
Coil resistance of solenoid valve No.2 (at 25_C) Ω 13 $ 2
Coil resistance of solenoid valve No.3 (at 25_C) Ω 13 $ 2
Stall speed r/min 2,320 ± 2,620
Line pressure kPa at idle speed
D range 373 ± 422
R range 520 ± 579
at stall speed
D range 765 ± 863
R range 1,383 ± 1,628
LUBRICANTS
Items Specified lubricant Quantity ȏ
Transmission fluid DEXRON II or equivalent 7.2
Transfer oil Hypoid gear oil SAE 75W-90 or
75W-85W conforming to API GL-4
2.3
SEALANTS AND ADHESIVES
Items Specified sealant Remarks
Transfer control lever gasket 3M ATD Part No.8660 or equivalent Semi-drying sealant
Transfer control lever assembly
installation bolt
3M Stud Locking No.4170 or
equivalent
Anaerobic sealant
To Next Page
Loading...
