CHASSIS ELECTRICAL ± Combination Meters
54A-27
COMBINATION METERS
REMOVAL AND INSTALLATION
3
1
Section A ± A
Instrument panel
A
A
2
Clip
1
A
A
A
A
A
A
Clip position
Combination meter removal steps
1. Meter hood
2. Combination meter
Vehicle speed sensor removal
3. Vehicle speed sensor
INSPECTION
VEHICLE SPEED SENSOR INSPECTION
1. Lift up the vehicle.
2. Remove the vehicle speed sensor, and then connect the
vehicle speed sensor and a resistance (3 ± 10 kΩ) as
shown in the illustration.
3. Use a circuit tester to check that the voltage between
terminal 2 and terminal 3 changes when turning a shaft
of the vehicle speed sensor (4 pulses per each one turn).
Circuit
tester
Battery
Vehicle
speed
sensor
Resistance
(3 ± 10 kΩ)
Terminal number
To Next Page
Loading...
