INTERIOR ± Seat
52A-12
SEAT
FRONT SEAT
REMOVAL AND INSTALLATION
Caution: SRS
Before removal of the seat equipped with the side air bag module, refer to GROUP 52B ± SRS
Service Precautions and Air Bag Module.
44 Nm
2
3
2
4
5
1
29 Nm
6
44 Nm
3
Front floor
console box
44 Nm
44 Nm
6
4
5
3
29 Nm
3
1. Heated seat switch
<Vehicles with heated seat>
2. Headrestraint
Front seat assembly removal steps
3. Front seat anchor cover
4. Heated seat harness connector
<Vehicles with heated seat>
5. Side air bag module harness
connector <Vehicles with SRS side
air bag>
" AA 6. Front seat assembly
INSTALLATION SERVICE POINT
" AA FRONT SEAT ASSEMBLY INSTALLATION
Temporarily tighten the mounting nuts and bolts, and then
tighten them to the specified torque. Note that the bolts shown
in the illustration should be tightened with no load on the
seat cushion.
To Next Page
Loading...
