WHEEL AND TYRE ± On-vehicle Service/Wheel and Tyre
Spare tyre
Spare tyre
cover
31-4
ON-VEHICLE SERVICE
TYRE INFLATION PRESSURE CHECK
NOTE
For information on tyre inflation pressure, refer to the label
attached near the driver's side door striker.
TYRE WEAR CHECK
Measure the tread depth of tyres.
Limit: 1.6 mm
If the remaining tread depth is less than the limit, replace
the tyre.
NOTE
When the tread depth of tyres is reduced to 1.6 mm or less,
wear indicators will appear.
WHEEL RUNOUT CHECK
Jack up the vehicle so that the wheels are clear of the floor.
While slowly turning the wheel, measure wheel runout with
a dial indicator.
Limit:
Item Steel wheel Aluminium wheel
Radial runout mm 1.2 1.0
Lateral runout mm 1.2 1.0
If wheel runout exceeds the limit, replace the wheel.
WHEEL AND TYRE
INSTALLATION SERVICE POINT
Tighten the wheel nut to the specified torque.
Tightening torque: 98 Nm
When installing the spare tyre and spare tyre cover to the
spare tyre carrier, tighten the wheel nut, lock cylinder and
bolt to the specified torque.
Tightening torque: 46 Nm
Radial
Lateral
To Next Page
Loading...
