Mitsubishi Pajero Pinin 1999 - Sealant; Service Specifications

GDI ± Service Specifications/Sealant
13A-7
SERVICE SPECIFICATIONS
Item Standard value
Adjustment voltage of throttle position sensor
(1st channel) V
0.4 ± 0.6
Adjustment voltage of throttle position sensor
(2nd channel) V
4.2 ± 4.8
Resistance of throttle position sensor kΩ 3.5 ± 6.5
Adjustment voltages (1st channel) and (2nd channel) of
accelerator pedal position sensor V
0.935 ± 1.135
Resistance (1st channel) and (2nd channel) of accelerator
pedal position sensor kΩ
3.5 ± 6.5
Intake air temperature sensor
resistance kΩ
at 20_C 2.3 ± 3.0
res
i
s
t
ance
kΩ
at 80_C 0.30 ± 0.42
Engine coolant temperature
sensor resistance kΩ
at 20_C 2.1 ± 2.7
sensor res
i
s
t
ance
kΩ
at 80_C 0.26 ± 0.36
Fuel pressure
High-pressure side MPa 4 ± 6.9
Low-pressure side kPa Approximately 324
Injector coil resistance Ω 0.9 ± 1.1
Oxygen sensor output voltage (at racing) V 0.6 ± 1.0
Oxygen sensor heater resistance Ω 11 ± 18
Throttle valve control servo resistance Ω 1.35 ± 1.65
SEALANT
Item Specified sealant Remark
Engine coolant temperature sensor
threaded portion
3M Nut Locking Part No. 4171 or equivalent Drying sealant