CLUTCH ± On-vehicle Service
21-3
3. If the clutch pedal height and the clutch pedal clevis pin
play are outside the standard value, turn the setting nut
to adjust them to the standard value.
Caution
Do not push in the master cylinder push rod at this
time, otherwise the clutch will not operate properly.
4. After completing the adjustments, confirm that the clutch
pedal free play (measured at the face of the pedal pad)
and the distance between the clutch pedal (the face of
the pedal pad) and the toeboard when the clutch is
disengaged are within the standard value ranges.
Standard value (C): 6 ± 13 mm
Standard value (D): 110 mm or more
5. If the clutch pedal free play and the distance between
the clutch pedal and the toeboard when the clutch is
disengaged do not agree with the standard values, it is
probably the result of either air in the hydraulic system
or a faulty master cylinder, release cylinder or clutch. Bleed
the air, or disassemble and inspect the master cylinder,
release cylinder or clutch.
6. Turn back the carpet, etc.
BLEEDING
Specified fluid: Brake fluid DOT 3 or DOT 4
Caution
Use the specified brake fluid. Avoid using a mixture of
the specified fluid and other fluid.
Setting nut
Clutch pedal
12 Nm
Clutch pedal free
play
C
Distance between the
clutch pedal and the
toeboard when the
clutch is disengaged
D
Clutch release cylinder
To Next Page
Loading...
