CHASSIS ELECTRICAL ± Headlamp, Front Turn-signal Lamp and Front Fog Lamp
54A-31
ON-VEHICLE SERVICE
HEADLAMP AIMING
<USING A BEAM SETTING EQUIPMENT>
1. The headlamps should be aimed with the proper beam
setting equipment, and in accordance with the equipment
manufacture's instructions.
NOTE
If there are any regulations pertinent to the aiming of
headlamps in the area where the vehicle is to be used,
adjust so as to meet those requirements.
2. Alternately turn the adjusting screw to adjust the headlamp
aiming. (Refer to P.54A-32.)
<USING A SCREEN>
1. Inflate the tyres to the specified pressures and there should
be no other load in the vehicles other than driver or
substituted weight of approximately 75 kg placed in driver's
position.
2. Put the headlamp leveling switch in ª0º position.
3. Set the distance between the screen and the centre marks
of the headlamps as shown in the illustration.
Screen
5 m
Headlamp centre line
Vehicle centre line
Lamp centre
To Next Page
Loading...
