BODY ± Keyless Entry System
42-40
8. Registration mode will be terminated under the following
conditions.
D When the encrypted codes for four transmitters have
been registered;
D When one minute has passed after registration mode
started;
D When the MUT-II is disconnected (earth is released);
D When the ignition key is removed;
9. After registration mode has been completed, carry out
the followings to make sure that the keyless entry system
operates.
D Pull the ignition key out.
D Close all of the doors.
HAZARD LAMP ANSWERBACK ADJUSTMENT
The following functions can be adjusted by operating input switches. The adjustments will be stored in
the ECU memory even after a battery cable is disconnected:
D Switching of keyless entry answerback function (From activation to desactivation, or viceversa)
D Initialization of all the ETACS functions (From desactivation to activation)
1. Entry conditions to the adjustment mode
The ETACS-ECU sounds a buzzer once when all of the following conditions are satisfied, and then
enters the adjustment mode:
D Hazard warning lamp switch: OFF
D Diagnosis control: ON (Connect the MUT-II or earth the diagnosis connector No.1 terminal.)
D Key reminder switch: OFF
D Ignition switch: LOCK (OFF)
D Driver's door switch: OFF (Close the driver's door.)
D If all of the conditions above are satisfied, the windshield washer switch will be turned on for
more than 10 seconds.
2. Exit conditions from the adjustment mode
The ETACS-ECU cancels the adjustment mode when any of the following conditions is satisfied:
D Diagnosis control: ON (Disconnect the MUT-II or disconnect the diagnosis connector No.1 terminal
from the earth.)
D Key reminder switch: ON (Pull out the ignition key.)
D Ignition switch: Other than LOCK (OFF)
D Driver's door switch: ON (Open the driver's door.)
D After the ETACS-ECU has entered the adjustment mode, no adjustment is made within 3 minutes
(If any adjustment is made within 3 minutes, the ETACS-ECU monitors a adjustment operation
for other 3 minutes.)
D Other warning buzzer(s) sounds
To Next Page
Loading...
