REAR AXLE ± Axle Assembly
27-9
AXLE ASSEMBLY
REMOVAL AND INSTALLATION
Caution
1. To prevent bushings from breakage, the parts indicated by * should be temporarily tightened,
and then fully tightened with the vehicle on the ground in the unladen condition.
2. Be careful not to strike the pole piece at the tip of the wheel speed sensor against the other
parts when removing and installing the wheel speed sensor.
Pre-removal Operation
D Brake Fluid Draining (Refer to GROUP 35A ±
On-vehicle Service.)
D Differential Gear Oil Draining
Post-installation Operation
D Brake Fluid Filling and Air Bleeding (Refer to
GROUP 35A ± On-vehicle Service.)
D Parking Brake Lever Stroke Adjustment (Refer to
GROUP 36 ± On-vehicle Service.)
D Differential Gear Oil Filling (Refer to P.27-7.)
14
2
7
59 Nm*
9
10
8
3
11
12
101 Nm*
81 Nm*
15 Nm
13
1
59 Nm
15
49 ± 59 Nm
16
4
49 Nm
6
5
17
18
60 Nm
Removal steps
AA" 1. Rear propeller shaft connection
2. Caliper assembly
3. Brake disc
4. Parking brake shoe assembly (Re-
fer to GROUP 36 ± Parking Brake
Drum.)
5. Parking brake cable connection
6. Wheel speed sensor <Vehicles with
ABS>
7. O-ring <Vehicles with ABS>
8. Spring support
AB" 9. Shock absorber connection
10. Coil spring (Refer to GROUP 34 ±
Rear Suspension Assembly.)
11. Silencer sheet
12. Bump stopper
13. Lower spring pad
AC" 14. Lateral rod connection
15. Rear brake pipe and hose connec-
tion
16. Upper arm connection
17. Lower arm connection
AD" 18. Axle assembly
To Next Page
Loading...
