FRONT AXLE ± Free-wheeling Clutch Assembly
26-45
FREE-WHEELING CLUTCH ASSEMBLY
REMOVAL AND INSTALLATION
Caution
To prevent bushings from breakage, the parts indicated by * should be temporarily tightened, and then
fully tightened with the vehicle on the ground in the unladen condition.
Pre-removal and Post-installation Operation
D Gear Oil Draining and Refilling (Refer to P.26-11.)
D Drive Shaft Removal and Installation
(Refer to P.26-19.)
35 Nm
49 Nm
4
Sealant:
3M ATD Part No.8661 or equivalent
1
4
5
59 ± 69 Nm
93 Nm*
103 Nm
49 ± 59 Nm
3
2 ± 3 mm
Removal steps
AA" 1. Pin
2. Free-wheeling engage switch
assembly
3. Differential mount bracket assembly
<LH>
4. Free-wheeling clutch housing
assembly
5. Collar
REMOVAL SERVICE POINT
AA" PIN REMOVAL
1. Remove the one side of the dust cover from the vacuum
actuator assembly.
2. Align the pin with the pin hole of the collar, and then
drive out the pin with a punch.
Collar Dust cover
Pin
To Next Page
Loading...
