BODY ± Back Door
42-33
BACK DOOR
SERVICE SPECIFICATION
Item Standard value
Back door handle play mm 2.0 ± 8.0
SEALANT
Item Specified sealant Remark
Waterproof film 3M ATD Part No. 8625 or equivalent Ribbon sealer
SPECIAL TOOL
Tool Number Name Use
MB990784 Ornament remover Back door trim removal
TROUBLESHOOTING
The central door locking (back door) is controlled by the Smart Wiring System (SWS). For troublesshooting,
refer to GROUP 54B ± Troubleshooting.
ON-VEHICLE SERVICE
BACK DOOR FIT ADJUSTMENT
1. If the striker and latch mesh badly, move the striker forward
and backward or right and left to adjust.
2. If uneven clearance is present between back door and
body, reposition the hinge and striker and/or change the
thickness of shim (change the number of shim) to adjust
the clearance.
BACK DOOR HANDLE PLAY CHECK
1. Measure the back door handle play.
Standard value (B): 2.0 ± 8.0 mm
2. If the back door handle play is not within the standard
value, check the back door handle and door latch assembly.
Replace if necessary.
Section A ± A
B
A
A
To Next Page
Loading...
