SRS ± Air Bag Module and Seat Belt Pre-tensioner Disposal Procedures
52B-60
DEPLOYED AIR BAG MODULE OR OPERATED
SEAT BELT PRE-TENSIONER DISPOSAL
PROCEDURES
After deployment or operation, the air bag module and the
seat belt pre-tensioner should be disposed of in the same
manner as any other scrap parts, adhering to local laws and/or
legislation that may be in force except that the following points
should be carefully noted during disposal.
1. The inflator will be quite hot immediately following
deployment, so wait at least 30 minutes to allow it cool
before attempting to handle it.
2. Do not put water or oil on the air bag after deployment
or on the seat belt pre-tensioner after operation.
3. There may be, adhered to the deployed air bag module
or the operated seat belt pre-tensioner, material that could
irritate the eye and/or skin, so wear gloves and safety
glasses when handling a deployed air bag module or a
operated seat belt pre-tensioner.
Caution
If after following these precautions, any material does
get into the eyes or on the skin, immediately rinse
the affected area with a large amount of clean water.
If any irritation develops, seek medical attention.
4. Tightly seal the air bag module and seat belt pre-tensioner
in a strong vinyl bag for disposal.
5. Be sure to always wash your hands after completing this
operation.
Strong
vinyl bag
Air bag module
and seat belt
pre-tensioner
To Next Page
Loading...
