FRONT AXLE ± Hub and Knuckle Assembly
26-18
3. Use the special tool to measure the hub rotation starting
torque.
Limit
: within 1.6 Nm
4. Make sure that the hub rotation starting torque is within
the limit, and the hub turns smoothly.
" DA WHEEL BEARING AXIAL PLAY CHECK
1. Clamp the knuckle in a vise, and measure the axial play
while moving the hub in the axial direction.
Limit
: 0.2 mm
2. If the limit value can not be obtained after tightening
the special tool within 196 ± 255 Nm, the wheel bearing,
the knuckle and the hub may be improperly assembled.
Disassemble these parts to replace the bearing, and then
assemble them again.
" EA INNER OIL SEAL INSTALLATION
MB990326
196 ± 255 Nm
MB991000
(MB990998)
MB991017
MB991389
To Next Page
Loading...
