FRONT AXLE ± Hub and Knuckle Assembly
26-17
2. Use the special tool to remove the wheel bearing outer
inner race from the hub.
Caution
Be careful not to drop the hub when the outer inner
race is pressed out.
3. Assemble the removed outer inner race to the wheel
bearing, and then use the special tools to remove the
wheel bearing.
REASSEMBLY SERVICE POINTS
" AA WHEEL BEARING INSTALLATION
Caution
When the wheel bearing is pressed in, its outer race should
be pushed in.
" BA OUTER OIL SEAL INSTALLATION
" CA HUB ROTATION STARTING TORQUE CHECK
1. Tighten the special tools to the specified torque to press
the hub into the knuckle.
2. Rotate the hub so that the hub is lubricated sufficiently.
MB990810
Outer inner
race
Outer inner race
MB991056 or MB991355
MB990932
MB990938
MB990938
MB991050
MB991387
MB991017
MB991000
(MB990998)
Bolt
196 ± 255 Nm
Tighten the nut
while holding the
bolt.
To Next Page
Loading...
