FRONT AXLE ± Hub and Knuckle Assembly
26-16
DISASSEMBLY AND REASSEMBLY
6
3
2
4
5
6
1
2
1
4
Lip
Disassembly steps
1. Inner oil seal
AA" 2. Hub
3. Snap ring
AB" 4. Wheel bearing
5. Outer oil seal
6. Knuckle
Reassembly steps
6. Knuckle
" AA 4. Wheel bearing
3. Snap ring
" BA 5. Outer oil seal
2. Hub
" CA D Hub rotation starting torque check
" DA D Wheel bearing axial play check
" EA 1. Inner oil seal
DISASSEMBLY SERVICE POINTS
AA" HUB REMOVAL
Caution
When the hub is removed, the wheel bearing may be
damaged. Therefore, if the hub is withdrawn, the wheel
bearing should be always be replaced with a new one.
AB" WHEEL BEARING REMOVAL
1. Pry the outer oil seal at the shown positions with a
screwdriver so that the jaws of the special tool can hook
the wheel bearing outer inner race.
MB991056 or
MB991355
MB991017
MB991000
(MB990998)
Tighten the nut while
holding the bolt,
Wheel bearing
outer inner
race
Outer oil seal
To Next Page
Loading...
