FRONT AXLE ± Hub and Knuckle Assembly
26-15
AB" TIE ROD END/LOWER ARM REMOVAL
Caution
1. Only loosen the ball joint nut, but do not remove it.
Use the special tool.
2. Suspend the special tool with a cord to prevent it
from dropping.
AC" DRIVE SHAFT REMOVAL
Use the special tools when the drive shaft can not be separated
from the knuckle easily due to seizure.
INSTALLATION SERVICE POINTS
" AA WASHER/CASTLE NUT INSTALLATION
1. Face the chamfered side of the washer against the castle
nut.
2. Use the special tool to tighten the castle nut securely.
Caution
Never apply the vehicle weight to the wheel bearing
while the castle nut is loosened. If the vehicle weight
is applied, the wheel bearing will be damaged.
3. If the split pin hole is not aligned with the castle nut slit,
always tighten the nut further within a torque of 255 Nm,
and assemble the split pin in the first aligned slit and
the hole.
Nut
Ball joint
Cord
MB991113 or
MB991406
MB990244
(three
pieces)
MB991354
MB990242
MB990767
Washer
196 ± 255 Nm
MB990767
To Next Page
Loading...
