REAR AXLE ± Differential Carrier
27-16
AB" DIFFERENTIAL CARRIER REMOVAL
Loosen the differential carrier mounting nuts to the end of
each stud bolt, and then strike the lower part of differential
carrier with a piece of timber several times to separate the
differential carrier from the axle housing.
Caution
1. Do not remove the differential carrier mounting nuts
so that the differential carrier will not fall when
separating it from the axle housing.
2. Do not strike the companion flange.
INSTALLATION SERVICE POINT
" AA REAR PROPELLER SHAFT CONNECTION
Connect the propeller shaft so that the mating marks on the
flange yoke and the companion flange of differential carrier
are aligned.
INSPECTION BEFORE DISASSEMBLY
For the inspection procedure except for the standard values
below, refer to GROUP 26 ± Inspection Before Disassembly.
FINAL DRIVE GEAR BACKLASH
Standard value: 0.08 ± 0.13 mm
DIFFERENTIAL GEAR BACKLASH
Standard value: 0.01 ± 0.25 mm
To Next Page
Loading...
