GDI ± InjectorGDI ± Injector
13A-112
REMOVAL SERVICE POINTS
AA" INJECTOR HARNESS CONNECTOR
DISCONNECTION
Caution
Disconnect the battery (±) cable from its terminal before
carrying out this operation.
AB" DELIVERY PIPE ASSEMBLY/FUEL INJECTOR
ASSEMBLY REMOVAL
Remove the delivery pipe assembly with the fuel injector
assembly still attached.
Caution
Be careful not to drop the fuel injector assembly when
removing the delivery pipe assembly.
INSTALLATION SERVICE POINTS
" AA CORRUGATED WASHER INSTALLATION
Caution
The corrugated washer should always be replaced with
a new part.
" BA FUEL INJECTOR ASSEMBLY/DELIVERY PIPE
ASSEMBLY INSTALLATION
1. Apply a small amount of fresh engine oil to the O-ring.
Caution
Take care not to let any of the engine oil get inside
the delivery pipe assembly.
2. While being careful not to damage the O-ring, turn the
fuel injector assembly to the left and right and connect
it to the delivery pipe assembly. After connecting, check
that the fuel injector turns smoothly.
3. If the fuel injector does not turn smoothly, the cause may be
that the O-ring is getting caught. Remove the fuel injector,
check the O-ring for damage and re-connect the fuel
injector to the delivery pipe assembly and then re-check.
Corrugated washer
To Next Page
Loading...
