ENGINE ELECTRICAL ± Starting System
16-24
DISASSEMBLY SERVICE POINTS
AA" MAGNETIC SWITCH REMOVAL
Disconnect the field coil wire from M-terminal of the magnetic
switch.
AB" ARMATURE AND BALL REMOVAL
When removing the armature, do not lose the ball placed
at the end as a bearing.
AC" SNAP RING/STOP RING REMOVAL
1. Using an appropriate wrench socket, push the stop ring
toward the overrunning clutch.
2. Remove the snap ring with snap ring pliers and then remove
the stop ring and overrunning clutch.
STARTER MOTOR PARTS CLEANING
1. Do not immerse the parts in cleaning solvent. Immersing
the yoke and field coil assembly and/or armature will
damage insulation. Wipe these parts with a cloth only.
2. Do not immerse the drive unit in cleaning solvent. The
overrunning clutch is pre-lubricated at the factory and
solvent will wash lubrication from clutch.
3. The drive unit may be cleaned with a brush moistened
with cleaning solvent and wiped dry with a cloth.
Magnetic
switch
S-terminal
M-terminal
Field coil
wire
Stop ring
Socket
Pinion gear
Overrunning
clutch
Snap ring
Pinion gear
Over-
running
clutch
Snap ring pliers
To Next Page
Loading...
