AUTOMATIC TRANSMISSION ± Transmission Assembly
23-58
REMOVAL SERVICE POINTS
AA" STARTER MOTOR REMOVAL
Remove the starter motor with the starter motor harnesses
still connected, and secure it inside the engine compartment.
AB" DRIVE PLATE CONNECTION BOLTS REMOVAL
1. Remove the connection bolts (6 places) while turning the
crankshaft.
2. Press in the torque converter to the transmission side
so the torque converter does not remain on the engine
side.
INSTALLATION SERVICE POINTS
" AA TRANSMISSION ASSEMBLY INSTALLATION
Press in the torque converter to the transmission side
completely, and then install the transmission assembly to the
engine.
" BA TRANSMISSION MOUNT STOPPER INSTALLATION
1. Install the transmission mount stopper so that the arrow
faces the direction shown.
NOTE
Disregard F and R stamped as a shared part.
2. The sizes of the mounting bolts are different. So be sure
not to confuse them.
Bolt Diameter x Length mm
A 10 x 50
B 10 x 60
C 10 x 40
25.9 mm
Transmission
mount stopper
Front of
vehicle
Transmission
mount insulator
assembly
A
B
B
A
C
Starter motor
4G9 only
Diameter
Length
To Next Page
Loading...
