PROPELLER SHAFT ± Propeller Shaft
25-4
REMOVAL SERVICE POINT
A FRONT PROPELLER SHAFT ASSEMBLY/REAR
PROPELLER SHAFT ASSEMBLY REMOVAL
1. Make mating marks on the differential companion flange
and flange yoke, and then remove the propeller shaft
assembly.
2 Cover the transmission and transfer not to allow foreign
materials to enter.
INSTALLATION SERVICE POINT
A REAR PROPELLER SHAFT ASSEMBLY/FRONT
PROPELLER SHAFT ASSEMBLY INSTALLATION
When reusing the propeller shaft, align the mating marks made
during the removal and install the propeller shaft assembly
to the companion flange.
Caution
1. Wipe out oil and grease on the threads of the mounting
bolts and nuts before tightening, or they will loosen.
2. Do not damage the oil seal lips of the transmission
and transfer.
INSPECTION
PROPELLER SHAFT RUNOUT
Limit:
Front propeller shaft: 0.5 mm
Rear propeller shaft: 0.4 mm
REAR PROPELLER SHAFT
1. Measure length A.
Standard value:
630 ± 1.5 mm
2. If the standard value is not met, replace the rear propeller
shaft.
Oil seal
A
To Next Page
Loading...
