FRONT AXLE ± Drive Shaft
26-22
Disassembly steps
" BA 1. D.O.J. boot band (small)
" BA 2. D.O.J. boot band (large)
3. Circlip
4. D.O.J. outer race
5. Snap ring
6. Inner race, cage, ball assembly
AA" " AA 7. D.O.J. boot
8. B.J. boot band (small)
9. B.J. boot band (large)
10. B.J. boot
11. B.J. assembly
12. Circlip
13. Dust cover
DISASSEMBLY SERVICE POINT
AA" D.O.J. BOOT REMOVAL
Wrap a plastic tape around the B.J. assembly spline to
prevent the boot from damage.
REASSEMBLY SERVICE POINTS
" AA D.O.J. BOOT INSTALLATION
Wrap a plastic tape around the B.J. assembly spline to
prevent damage, and then install the boot.
" BA D.O.J. BOOT BAND/BOOT BAND INSTALLATION
1. Slide the D.O.J. outer race so that the distance between
the boot bands meet the standard value in order to adjust
the air amount inside the D.O.J. boot.
Standard value (A): 80 ± 3
mm
2. Remove the boot partially from the D.O.J. outer race
in order to bleed the air from the boot.
B.J. BOOT (PLASTIC BOOT) REPLACEMENT
1. Remove the boot bands (small and large).
NOTE
The boot bands are non-reusable parts.
2. Remove the plastic boot.
A
To Next Page
Loading...
