FRONT AXLE ± Drive Shaft
26-25
14. Check that the crimping amount (E) of the B.J. boot band
is at the standard value.
Standard value (E): 2.4 ± 2.8 mm
<If the crimping amount is larger than 2.8 mm>
Readjust the value of (W) in step 11 according
to the following formula, and then repeat the
operation in step 13.
W = 5.8 mm ± E
Example: If E = 2.9 mm, then W = 2.9 mm.
<If the crimping amount is smaller than 2.4 mm>
Remove the B.J. boot band, readjust the value
of (W) in step 11 according to the following
formula, and then repeat the operations in
steps 12 and 13 using a new B.J. boot band.
W = 5.8 mm ± E
Example: If E = 2.3 mm, then W = 3.5 mm.
15. Check that the B.J. boot band is not sticking out past
the place where it has been installed.
If the B.J. boot band is sticking out, remove it and then
repeat the operations in steps 12 to 14 using a new B.J.
boot band.
E
To Next Page
Loading...
