Mitsubishi Pajero Pinin 1999 - Page 397

FRONT AXLE ± Differential Carrier
26-37
" BA DRIVE PINION FRONT BEARING OUTER RACE
INSTALLATION
" CA DRIVE PINION REAR BEARING OUTER RACE
INSTALLATION
" DA DRIVE PINION HEIGHT ADJUSTMENT
Adjust the drive pinion height by the following procedure.
1. Apply multipurpose grease to the washer of the special
tool.
2. Install the special tool, drive pinion front and rear bearing
inner races to the gear carrier.
3. Tighten the nut of the special tool while measuring the
rotation torque of the drive pinion. Gradually keep
tightening the nut of the special tool until the rotation
torque of the drive pinion (without oil seal) is at the standard
value.
Standard value:
Bearing division Bearing lubrication Rotation torque
Nm
New None (With
anti-rust agent)
0.88 ± 1.17*
1
0.29 ± 0.49*
2
New or reused Gear oil applied 0.39 ± 0.49*
1
0.147 ± 0.245*
2
NOTE
*
1
: A/T
*
2
: M/T
MB990938
MB990926
MB990938
MB990929
MB990903
<M/T>
MB990835
<A/T>
MB990836
(MB990835)
<A/T>
Washer
MB990903 <M/T>
MB990835 <A/T>