FRONT AXLE ± Free-wheeling Clutch Assembly
26-47
DISASSEMBLY SERVICE POINT
AA" BEARING REMOVAL
Position the bearing inner race on a support. Then use a
press to separate the clutch gear from the bearing.
REASSEMBLY SERVICE POINTS
" AA OIL SEAL INSTALLATION
" BA BEARING INSTALLATION
Use the special tool to press-fit the bearing to the shoulder
of the clutch gear.
" CA SPRING PIN INSTALLATION
Insert the spring pin into the pin hole (with chamfered surface)
of the shift rod, and then tap the spring pin in as shown
in the illustration.
" DA CLUTCH SLEEVE INSTALLATION
Face the clutch sleeve tapered side towards the drive shaft
to install the clutch sleeve.
Support
MB991015
MB990938
MB990799
Shift fork
Shift rod
Spring pin
0 ± 1 mm
Taper side
Drive shaft
side
Differential carrier
side
To Next Page
Loading...
