REAR AXLE ± Differential Carrier
27-21
REASSEMBLY SERVICE POINTS
" AA DRIVE PINION REAR BEARING OUTER RACE
PRESS-FITTING
Use the special tools to tap in the drive pinion rear bearing
outer race.
" BA DRIVE PINION FRONT BEARING OUTER RACE
PRESS-FITTING
Use the special tools to tap in the drive pinion front bearing
outer race.
" CA DRIVE PINION HEIGHT ADJUSTMENT
Adjust the drive pinion height by the following procedures:
1. Apply multipurpose grease to the washer of special tool.
2. Install the special tools and drive pinion front and rear
bearing inner races to the differential carrier in the
sequence shown in the illustration.
3. Gradually tighten the nut of the special tool while checking
the drive pinion turning torque until the standard value
of drive pinion turning torque (without oil seal) is obtained.
Standard value:
Bearing Bearing lubrication Turning
torque Nm
New None
(with anti-rust agent)
0.59 ± 0.88
New or reusing Gear oil applied 0.39 ± 0.49
MB990938
MB990936
MB990938
MB990934
Washer
MB990819
For drive pin-
ion attach-
ment, use
MB991169.
MB990819
MB990326
MB990685
To Next Page
Loading...
