POWER PLANT MOUNT ± Transmission Mounting
32-3
TRANSMISSION MOUNTING
REMOVAL AND INSTALLATION
Caution
Provisionally tighten the parts marked by an asterisk (*), and then fully tighten after loading the
full weight of the transmission on the vehicle body.
Pre-removal and Post-installation Operation
Jack up the Engine and Transmission Assembly until
there is no weight on the Engine Mount Bracket Insulator.
93 Nm*
3
49 Nm
49 Nm
49 Nm
2
1
4
7
5
6
Removal steps
1. Washer
2. Spacer
3. Transmission mount bushing
4. Transmission mount crossmember
assembly
5. Transmission mount insulator assembly
"AA 6. Transmission mount stopper
7. Adaptor
INSTALLATION SERVICE POINT
"AA TRANSMISSION MOUNT STOPPER INSTALLATION
Install the transmission mount stopper so that the arrow faces
the direction shown.
NOTE
Disregard F and R stamped as a shared part.
Transmission
mount stopper
Front of
vehicle
Transmission
mount insula-
tor assembly
To Next Page
Loading...
