BASIC BRAKE SYSTEM ± On-vehicle Service
35A-11
DISC BRAKE PAD CHECK AND REPLACEMENT
NOTE
The brake pads have wear indicators that contact the brake
disc when the brake pad thickness reaches approximately
2 mm and emit a squealing sound to warn the driver.
1. Check the brake pad thickness through the caliper body
check port.
Standard value: 10.0 mm
Limit: 2.0 mm
2. When the thickness is less than the limit, always replace
the pads at an axle set.
3. Remove the guide lock pin bolt. Pivot the caliper assembly
and hold it with wires.
4. Remove the following parts from the caliper support.
1. Pad and wear indicator assembly
2. Pad assembly
3. Clip
4. Inner shim
5. Outer shim
5. In order to measure the brake drag force after pad
installation, measure the rotary-sliding resistance of the
hub with the pads removed. (Refer to P.35A-20, 25.)
6. Install the pads and caliper assembly, and then check
the brake drag force. (Refer to P.35A-21, 26.)
FRONT
REAR
4
2
5
3
1
3
3
1
4
3
2
5
FRONT REAR
To Next Page
Loading...
