BASIC BRAKE SYSTEM ± Master Cylinder and Brake Booster
35A-18
2. If the protrusion amount is not within the standard value
range, adjust the push rod length by turning the push
rod. Use the special tool to turn the push rod while holding
the rod spline with angle-nose pliers.
" CA SEAL INSTALLATION
1. Apply silicone grease to the seal.
2. Install the seal to the master cylinder as shown.
INSPECTION
VACUUM SENSOR CHECK
Refer to GROUP 13A ± Troubleshooting.
NOTE
The vacuum sensor is monitored by the engine-ECU. Diagnosis
code is output when the vacuum sensor has a malfunction.
Angle-nose pliers
MB991568
Seal
Master cylinder
<L.H. drive vehicles with ABS>
<L.H. drive vehicles without ABS and R.H.
drive vehicles>
Master cylinder
Seal
To Next Page
Loading...
