BASIC BRAKE SYSTEM ± Rear Disc Brake
35A-25
REAR DISC BRAKE
REMOVAL AND INSTALLATION
Pre-removal Operation
D Brake Fluid Draining
Post-installation Operation
D Brake Fluid Supplying and Air Bleeding (Refer to
P.35A-10.)
2
3
55 ± 65 Nm
1
15 Nm
Removal steps
1. Brake hose connection
" AA 2. Disc brake assembly
3. Brake disc
INSTALLATION SERVICE POINT
" AA DISC BRAKE ASSEMBLY INSTALLATION
1. In order to measure the brake drag force after pad
installation, use a spring balance to measure the
rotary-sliding resistance of the hub with the pads removed.
2. Install the caliper support to the backing plate, and then
assemble the pad clip and the pad to the caliper support.
Caution
Do not contaminate the friction surfaces of the pads
and brake discs by any oil or grease.
To Next Page
Loading...
