Mitsubishi Pajero Pinin 1999 - Page 506

ABS <4WD> ± Troubleshooting
35B-7
When not using the MUT-II
1. Stop the engine.
2. Use the special tool to earth terminal (1) (diagnosis control
terminal) of the diagnosis connector.
3. Turn on the stop lamp switch. (Depress the brake pedal.)
4. After carrying out steps 1. to 3., turn the ignition switch
to ON. Within 3 seconds after turning the ignition switch
to ON, turn off the stop lamp switch (release the brake
pedal). Then, turn the stop lamp switch on and off a total
of 10 times.
NOTE
If the ABS-ECU function has been stopped because of
fail-safe operation, it will not be possible to erase the
diagnosis codes.
1st
2nd
3rd
4th
5th
6th
7th
8th
9th
10th
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
Within
1
second
1 second
Ignition switch
ON
LOCK (OFF)
Stop lamp switch
ON
OFF
ABS warning lamp
ON
OFF
ABS-ECU memory
Within 3
seconds
Erasing of
ABS-ECU
diagnosis
codes
complete.
MB991529