ABS <4WD> ± Troubleshooting
35B-21
RESISTANCE AND CONTINUITY BETWEEN
HARNESS-SIDE CONNECTOR TERMINALS
1. Turn the ignition key to the LOCK (OFF) position.
2. Disconnect the ABS-ECU connector. (Refer to P. 35B-27.)
3. Use the special tool to check the resistance and continuity
between the terminals indicated in the table below.
4. The terminal layout is shown in the illustration.
ABS±ECU terminal No. Signal Normal condition
1 ± 2 Wheel speed sensor (rear left)
1.30 ± 1.58 kΩ
4 ± 5 Wheel speed sensor (rear right)
14 ± 15 Wheel speed sensor (front left)
17 ± 18 Wheel speed sensor (front right)
21 ± Body earth Earth
Continuity
23 ± Body earth Earth
Check connector
MB991547
ABS-ECU
Body side harness
To Next Page
Loading...
