ABS <4WD> ± Wheel Speed Sensor
35B-29
WHEEL SPEED SENSOR
REMOVAL AND INSTALLATION
Post-installation Operation
Wheel Speed Sensor Output Voltage Check
(Refer to P.35B-22.)
1
2
4
3
<FRONT>
<REAR>
AA" 1. Front wheel speed sensor
2. Front ABS rotor (Refer to GROUP
26 ± Drive Shaft.)
AA" 3. Rear wheel speed sensor
4. Rear ABS rotor (Refer to GROUP
27 ± Axle Shaft.)
NOTE
The front ABS rotor is integrated with the drive shaft. Do
not disassemble it.
REMOVAL SERVICE POINT
AA" FRONT WHEEL SPEED SENSOR/REAR WHEEL
SPEED SENSOR REMOVAL
Caution
Do not strike the pole piece at the tip of the wheel speed
sensor against the ABS rotor tooth surface or other parts
when removing the wheel speed sensor.
Pole piece
To Next Page
Loading...
