ABS <4WD> ± G Sensor
35B-31
G SENSOR
REMOVAL AND INSTALLATION
Caution
Do not drop the G sensor or subject it to any shocks.
Pre-removal and Post-installation Operation
Rear floor console removal and installation
(Refer to Group 52A.)
5 Nm
G sensor
INSPECTION
1. Remove the G sensor.
2. Connect the special tool between the disconnected
connectors, and then place the G sensor horizontally as
shown in the illustration.
3. Turn on the ignition switch, and then measure the voltage
between terminal No.2 and body earth.
Standard value: 2.4 ± 2.6 V
4. Face the labeled surface straight down with the special
tool still connected. Measure the voltage between terminal
No.2 and body earth with the labeled surface faced straight
down.
Standard value: 3.3 ± 3.7 V
5. If not within the standard value, check the power supply
line and earth condition, and then replace the G sensor.
MB991348
Label
Label
To Next Page
Loading...
