Mitsubishi Pajero Pinin 1999 - Page 555

STEERING ± Steering Wheel and Shaft
37A-14
DISASSEMBLY AND REASSEMBLY
BW0581AL
1
4
3
2
AW1122AL
<L.H. drive vehicles> <R.H. drive vehicles>
5
17 Nm
1
2
3
5
Disassembly steps
AA" " AA 1. Special bolt
" AA 2. Steering lock bracket
" AA 3. Steering lock cylinder assembly
4. Shaft assembly
<L.H. drive vehicles>
5. Steering column shaft assembly
DISASSEMBLY SERVICE POINT
AA" SPECIAL BOLT REMOVAL
1. In the special bolt, drill a hole deep enough for the tap
to stand.
2. Using a left-hand tap, remove the special bolt.
REASSEMBLY SERVICE POINT
" AA STEERING LOCK CYLINDER ASSEMBLY/
STEERING LOCK BRACKET/SPECIAL BOLT
INSTALLATION
1. When installing the steering lock cylinder assembly and
steering lock bracket to the steering column assembly,
temporarily install the steering lock in alignment with the
column boss.
2. Check that the steering lock works properly. Then, tighten
the special bolts until the heads twists off.
Steering
lock bracket
Steering lock body
Special bolt
Left-hand tap