STEERING ± Power Steering Gear Box and Linkage
37A-28
" MATIE ROD END/LOCKING NUT INSTALLATION
Screw in the tie rod end until the dimension shown is achieved.
Then, temporarily tighten with the locking nut.
NOTE
The locking nut must be tightened securely only after the power
steering gear box and linkage are installed to the vehicle and
toe±in is adjusted.
TIE ROD END BALL JOINT DUST COVER
REPLACEMENT
Only when the dust cover is damaged accidentally during
service work, replace the dust cover as follows:
1. Apply grease inside a new dust cover.
2. Using the special tool, press in the dust cover to the tie
rod end.
3. Check the dust cover for cracks or damage by pushing
it with finger.
Edge of bellows
assembly groove
Locking nut
212 mm
MB990776
To Next Page
Loading...
